Standards And Compliances - ATTO Technology FibreBridge 1190E Installation And Operation Manual

Appendix B Standards and compliances
The equipment described in this manual generates and uses radio frequency energy. If this equipment is
not used in strict accordance with the manufacturer's instruction, it can and may cause interference with
radio and television reception. See the Technical Specification sheet for a particular ATTO
TM
FibreBridge for a full list of certifications for that model.
FCC Standards: Radio and Television Interference
WARNING This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause interference to radio communications. It has been tested and found
to comply with the limits for a Class A computing device pursuant to Subpart J of Part 15 of FCC rules, which are
designed to provide a reasonable protection against such interference when operating in a commercial environment.
Operation of this equipment in a residential area is likely to cause interference, in which case the user, at his own
expense, will be required to take whatever measures may be required to correct the interference.
If this equipment does cause interference to radio and television reception, which can be determined by
turning the equipment off and on, try to correct the interference by one or more of the following
measures:
➔ Move the receiving antenna.
➔ Relocate the bridge with respect to the receiver, or move the bridge away from the receiver.
➔ Plug the computer into a different outlet so the computer and receiver are on different branch
circuits.
➔ If necessary, consult an ATTO authorized dealer, ATTO Technical Support Staff, or an
experienced radio/television technician for additional suggestions.
The booklet How to Identify and Resolve Radio/TV Interference Problems prepared by the Federal
Communications Commission is a helpful guide. It is available from the US Government printing office,
Washington, DC 20402, Stock No. 004-000-00345-4.
Further results of FCC Testing
"In certain instances, extraordinary variances in the AC power supplied to this unit will require the
operating system's normal error recovery procedure to retry the current SCSI command. In this case, the
unit can fully recover with no loss of data, and without user intervention. Note that other exceptional
conditions in addition to variances in the AC power, such as improper cabling or unrecognized
commands, may also trigger these normal error recovery procedures."
Canadian Standards
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing
Regulations.
Cet appareil numerique de la classe A respecte toutes les exigences du Reglement sur le materiel
brouilleur du Canada.
vi ATTO Technology FibreBridge 1190E Installation and Operation Manual