Table of Contents
Advertisement
Ethernet port
The 10/100 Base T Ethernet port supports SNMP-
and Telnet-based monitoring and management
through a command line interface or menu
system.
Serial port
The RS-232 serial port provides support for
remote monitoring and management through a
command line interface or menu system.
Serial/Ethernet RJ45 port
The RJ45 port may be used for either
serial or Ethernet connections depending
on the jumper settings and cable. The
factory sets the jumpers in a serial
configuration across the top and middle
rows of the selector header.
To enable an Ethernet configuration,
move all the jumpers in the selector
header to the middle and bottom rows.
Attach a standard Ethernet cable.
If using the RJ45 in a serial
configuration, create a serial cable
connection with the following pin outs:
Signal Name
TX
RX
Ground
LED indicators
➔ FC Activity: LED blinks to show
activity on the Fibre Channel port
Serial/Ethernet
RJ45 port
selector header
PCI
Connector
RJ45 Pin
1
2
6
(numbered 0). During very high activity,
the LED appears to be steadily lit.
➔ SCSI Activity: shows activity on the SCSI
bus (numbered 0).
➔ Ready: should light after power has been
applied; indicates the board has completed
the initialization process without any
failures and is ready to handle data
transfers.
Exhibit 3-2 FibreBridge 1190E board layout.
Ethernet / Serial
Dual stacked
Port Connector
SCSI Connector
4 Pin Power
Connector
Fibre Channel
SCSl activity
Connector
LED
Fibre Channel
and Ready/Fault
JTAG
Header
Reset
Jumper
RS232 Serial
port header
activity
LED
6
Advertisement
Table of Contents
