Fcinitiator; Fcportlist; Fcscsibusystatus; Fctargets - ATTO Technology FibreBridge 1190E Installation And Operation Manual

FcInitiator

Allows FibreBridge to operate as an initiator on the Fibre Channel network, an attribute required for features such as Extended Copy.
Actions: set FcInitiator [enabled | disabled]
SaveConfiguration

FcPortList

Returns a list of available Fibre Channel ports and their current status.
Limits: valid status values are OK and Failed
Actions: none

FcSCSIBusyStatus

Specifies the SCSI status value returned when the FibreBridge is unable to accept a SCSI command because of a temporary lack of resources.
Limits: [busy | qfull]
Actions: set FcSCSIBusyStatus [busy | qfull]
SaveConfiguration

FcTargets

Obtains information about every Fibre Channel target device visible to a FibreBridge operating in initiator mode; devices may be used as targets
for initiator mode features such as Extended Copy.
Actions: none

FcWWName

Reports the Word Wide Name (WWN) of the Fibre Channel interface. Each FC port has an individual and unique WWN. The least significant 6 bits
of the WWN are used as the Ethernet MAC address.
Limits: Fabric and loop operations are unpredictable if
duplicate WWNs are assigned.
Actions: none

FibreBridgeTargetLUN

Specifies the soft target LUN(s) to be used by the FibreBridge when addressed by the host as a SCSI device.
Limits: Any map coinciding with the user-specified FibreBridgeTarget LUN must first be set to offline before trying to change it. This
map will be destroyed upon power-cycling the FB.
Disabling a FibreBridgeTargetLUN for a particular FC port will destroy the map to the FB 1190 for that port.
The get form reports all FibreBridgeTargetLUNs currently NOT disabled. Specifying a port returns the status of that port.
Action: set FibreBridgeTargetLUN [fp] [fl] | [disabled] ]
SaveConfiguration
Information: get FcInitiator
Information: FcPortList
Returns: [line count] [fp] [status]
Default: busy
Information: get FcSCSIBusyStatus
Information: FcTargets
Returns: Node Name, FC LUN & inquiry data for each FC device
found
Information: get FcWWN [PortNumber]
Return: Port n FcWWName= 20 00 00 10 86 nn nn nn
Information: get FibreBRidgeTargetLUN <[fp]>
Returns:
[Line Count]
[fp] [fl]
24