Table of Contents
Advertisement
Zmodem
Allows transfer of a firmware image to or from the FibreBridge using the ZMODEM file transfer protocol.
Limits: available only through the RS232 interface
WARNING After a firmware image is downloaded to the FibreBridge, the image is placed into flash memory. During this
time (about 30 seconds), DO NOT remove power to the FibreBridge or the flash may become corrupted.
Actions: Zmodem [Send filename | Receive]
Information: none
SaveConfiguration
Returns: ZMODEM transfer complete on success
ERROR with status message on failure
28
Advertisement
Table of Contents
