Table of Contents
Advertisement
To connect via Telnet:
1
Supply the IP address to the Telnet program.
The local echo should be set to on if the
Telnet software supports it. Use Vt100 for
communication.
2
Verify that the bridge can be accessed on
the local Ethernet by using the Ping utility.
On most systems, type ping <IP Address>. If
the product module does not respond, it
may not be connected correctly to the
network, or is somehow unreachable by the
computer from which it is being pinged.
Check network connections and security as
well as the ATTO FibreBridge.
To set up and configure FTP:
1
Ensure that the FTP program is in binary
mode. Access the ATTO FibreBridge at the
IP address that was previously set (or the
default).
2
Log into the ATTO FibreBridge. The
username the bridge will accept is sysadmin.
Enter userid as the password.
3
Use the command line interface (CLI) as
explained in the following chapters.
12
Advertisement
Table of Contents
