Process Documentation - Miele PG 8583 CD Operating Instructions Manual

Memory
Adding cycle
numbers
Documenting processes
Processes are documented per cycle. Required and actual values are
always recorded.
During a program sequence, the following data is recorded, among
other things:
- Machine model and serial number
- Date
- Program start and program name
- Cycle number
- Wash blocks used
- Dispensing system with dispensing temperature and target dis-
pensing amount if necessary
- Target values for temperature and holding times
- Minimum and maximum temperatures during the holding time
- Wash pressure measuring results
- All fault messages
- End of program
- System messages, e.g., refill salt
Further data can be incorporated into the report as required. Contact
Miele Service for more information on this.
Depending on scale, between 10 and max. 20 batch protocols are
stored in an internal power failure safe memory within the machine. In
the event of network or printer problems, for example, these can be
subsequently recalled. If the memory is full, the oldest protocol is
overwritten.
In addition, raw data from the last program sequence is stored to cre-
ate a graphical display of the process data. This data can be trans-
formed into graphical representations using external documentation
software. Transferring raw data requires an Ethernet interface. It is not
possible to create graphical representations on the display or on a di-
rectly connected printer. Power-failure-safe storage of graphical infor-
mation is not available.
Miele Service can add subsequent cycle numbers, e.g., in the event
of software updates or if the machine controls are replaced.

Process documentation

117