Program settings
Allocating wash
blocks
102
Altering a program
You can alter all parameters which are identified as changeable in the
program charts. Other settings can only be altered by Miele Service.
A program setting is altered in two steps:
- First the wash blocks must be reallocated to the program or the ex-
isting allocation confirmed again. Only allocated program blocks
can be parameterized.
- Then the program parameters can be altered.
Use this option to document all changes to factory settings in case
of a subsequent Miele Service call requirement.
Changing program parameters on a validated machine will require a
new performance validation.
...
Program settings
Change program
Change program
Select the program you want to alter.
For more information, see "Allocating wash blocks."
For every program change, the wash blocks must first be allocated.
Normal plus
Allocation is by multiple choice. A box is shown next to all wash
blocks in the display. If a wash block is allocated to the program,
there is a check in the box. This wash block is allocated to the pro-
gram by ticking the box or the allocation can be removed by remov-
ing the tick.
The wash blocks can be selected or deselected using the and
arrow buttons and confirming with OK.
To save the selection, select the
and confirm with OK.
If you want to adopt the preset wash blocks without any changes,
you can confirm the
The further setting options will then follow. You can edit these in any
order you want.
Normal plus
Standard
Accept
Pre-rinse 1
Accept
Accept
option immediately with OK.
option at the end of the list