Wiring - Allen-Bradley Rockwell Automation 1734-AENT User Manua

2-4 Install the 1734-AENT Adapter

Wiring

Publication 1734-UM011A-EN-P - February 2004
7. Set the network address thumbwheel switches to the value used on the
replaced module (see Set the Network Address on page 3--6 in the next
chapter).
8. Insert the end of the terminal block (RTB) opposite the handle into the
base unit. This end has a curved section that engages with the wiring
base.
9. Rotate the terminal block into the wiring base until it locks itself into
place.
Refer to the illustration to wire the Ethernet adapter
Network Address
Thumbwheels
Ethernet RJ-45 Connector
NC = No Connection
CHAS GND = Chassis Ground
C = Common
V = Supply
ATTENTION
NC = No Connection
Chas GND = Chassis Ground
Module Status
Module
Status
0 2
0
Network Activity Status
Network Activity
Status
Network Status
Network
Status
PointBus PointBus Status
Status
1734-AENT
System Power
System
Power
Field Field Power
Power
NC
CHAS GND
C
V
Do not connect
120/240V ac power
to this supply.
This dc supply will be
V dc
connected to the
internal power bus.
C = Common
V = Supply
43264
12/24V dc
0
1
NC
NC
3
2
Chas Chas
Gnd Gnd
5
4
C
C
6 7
V
V