What This Appendix Contains; Install The Rslinx Software - Allen-Bradley Rockwell Automation 1734-AENT User Manua

What This
Appendix Contains
Install the
RSLinx Software
1
Configure the RSLinx Ethernet
Communication Driver
In order to communicate with your 1734-AENT adapter over your network
you must configure the RSLinx Ethernet communication driver (AB_ETH) or
the EtherNet/IP driver (AB-ETHIP). You can configure the AB_ETH driver
with the IP addresses of all the Ethernet devices on your system. You will need
one of these drivers to download the example application programs in this
manual.
The following table lists the contents of this appendix and where to find
specific information:
For information about

Install the RSLinx Software

Configure the AB_ETH Driver
Configure the AB_ETHIP Driver
ATTENTION
You must use Series C POINT I/O modules with the
1734-AENT adapter. Series A or B POINT I/O
modules will not work with this adapter.
Use the following procedure to install RSLinx software on your computer.
1. Insert the CD in the CD-ROM drive.
Note: The CD-ROM supports Windows Autorun. Once inserted into
the CD-ROM drive, if you have Autorun configured, the installation will
automatically start at the first setup screen.
If Autorun is not configured for your CD-ROM drive, go to step 2.
2. From the Start menu, choose Run.
You will see the Run pop-up window.
3. Type d:/setup (if it doesn't appear automatically), where d: is your
CD-ROM driver letter.
4. Click on OK.
Appendix
See page
B-1
B-2
B-4
Publication 1734-UM011A-EN-P - February 2004
B