About The Example Application; You Must Use Series C Point I/O Modules With The 1734-Aent Adapter. Series A Or B Point I/O - Allen-Bradley Rockwell Automation 1734-AENT User Manua

About the Example
Application
1
Configure the 1734-AENT for Direct
Connection in RSLogix 5000
In this example, a ControlLogix processor communicates with POINT I/O
via the 1734-AENT adapter using a direct connection. The adapter will make a
direct connection to each of the modules referenced by the data. Note that the
modules presented in this chapter are configured using RSLogix 5000, version
11.
What you will do
Set Up the Hardware
Create the Example Application
Configure the I/O
Add the Local EtherNet/IP Bridge to the I/O Configuration
Add the POINT I/O Adapter to the I/O Configuration
Add the POINT I/O Modules to the I/O Configuration
Add the Relay Output Module
Add the Digital Output Module
Edit the Controller Tags
Create the Ladder Program
Download the Program to the Controller
Verify the Module Chassis Size
Configure the 1734-AENT with Fixed IP Address
Configure the 1734-AENT with Fixed IP Address
An Overloaded 1734-AENT
ATTENTION
You must use Series C POINT I/O modules with the
1734-AENT adapter. Series A or B POINT I/O
modules will not work with this adapter.
Chapter
See page
4-2
4-3
4-4
4-4
4-6
4-8
4-8
4-11
4-13
4-14
4-15
4-16
4-18
4-18
4-19
Publication 1734-UM011A-EN-P - February 2004
4