Dx18 And Dx18Qq Transmitter File - BVM PNP VIPER Construction And Operating Manual

DX18 and DX18QQ Transmitter File

The BVM Demo models are setup on Spektrum DX18 transmitters. The file included on the
SD card has all the mixes, rates, expos, and settings done for you. Setting the sub trim and
travel adjustment must be accomplished by the modeler for the specific aircraft.
Important!!! Check the directions of all flight controls before each flight.
Switch/Lever/Trimmer
Switch A
Switch B
Switch C
Switch D
Switch E
Switch F
Switch G
NOTE: LIGHTS - The LED labeled wire plugs into a selected channel to operate the light
system.
NOTE: The BVM factory demo model flew
without Gyro assistance. If you opt to install
a Gyro, be sure to check for proper control
surface corrections. Have the Gyro
activated by a 3 position switch on your
transmitter. Make the first take-off with the
Gyro off until a safe altitude is attained.
First Flight Profile
Make the first flight with the gyro "OFF".
Flight Time – There is 9+ minutes of fuel on board.
The BVM demo model's transmitter timer was set for 7 min for a "Top Gun" routine. On the
first flight, land a few minutes early to check fuel consumption. Adjust the flight timer
accordingly.
BVM®2017
Channel
Aux3/Gear
X+3/Lights
Flight Rates
Flaps
Aux5/Brakes
X+1/Smoke
X+2/Gyro
28
Output
Landing Gear
Down is Off
Up is High
(0) Up is Normal flight
(1)Mid is Flaps Take‐Off
(2)Down is Landing Flaps
(0) Brakes Off
(1)Anti Lock
(2)Full Brake
(0) Off
(1)On Low
(2)On High
(0) Off
(1)Normal Flight
(2)High Landing
06/20/2017