Forward Battery Tray - BVM PNP VIPER Construction And Operating Manual

To pull the tailpipe further forward or to completely remove it through the aft fuse opening the
inlet lip must be removed. The stainless steel mounting straps can be carefully bent around
the pipe to pull it completely out of the fuse to the rear.
Some tailpipe lips are attached with very small Phillips head screws. To replace them use 4-
40 X 3/16" S.H.C.S. with flat washers and 4-40 hex nuts. Apply a drop of thread locker.

FORWARD BATTERY TRAY

(OPTIONAL INSTALLATION)
These plywood trays allow forward placement of 2 receiver batteries, engine ECU battery,
and an optional location for electric pumps. This is necessary for a proper Center of Gravity
with minimum if any ballast added.
View of bottom side of battery tray View of top side of tray and pump mount. A Zap or
resin finish is applied for better adhesion of Velcro
strips. Apply finish to both sides of the pump
mount.
NOTE: Sand top of plywood with #320 before and after applying finish.
See also: Forward Battery Tray later in this manual. The parts in your model will be one or
the other.
BVM®2017 21 06/20/2017