Connecting Rx Wires; Dx18 And Dx18Qq Transmitter File - BVM GO FLY GOLD PNP F-16 C Manual

Connecting RX wires

The wires are labeled from the factory. If you are using the DX18, the program is available on
a SD card from BVM. Follow the chart below to connect the servos.
DX18 Connection Chart
RX Port
Surface
RX Port
Surface

DX18 and DX18QQ Transmitter File

The BVM Demo models are setup on Spektrum DX18 transmitters. The file included on the
SD card has all the mixes, rates, expos, and settings done for you. Setting the sub trim and
travel adjustment must be accomplished by the modeler for the specific aircraft. Each aircraft
is tested at the factory using a similar program.
Important!!! Check the directions of all flight controls before each flight.
Switch/Lever/Trimmer Channel
Switch A
Switch B
Switch C
Switch D
Button I
L. Trim
Switch F
Switch G
Switch H
Right Lever
BVM ®2021
Throttle Aileron
Throttle Right Ail
Aux2 Aux3
Brakes Nose
Steering
Channel 5/Gear
X+1/Channel 11/Aux 6
Elevator Rates
Flaperons, Ail and Aux 1
Throttle Cut
Steering Trim/Aux 3
Aileron Rates
Rudder Rates
Aux 5/Smoke
Aux 2/Brakes
Elevator Rudder
Right Elev Rudder
Aux4 Aux5
Left Elev Smoke
Output
Landing Gear, Down is Down
Lights, Down is off, Up is on
Up (0) is High
Up is Normal flight
Mid is flaperon down w/ up elevator mix
Down is "Taileron Mix"- for high-alpha
Throttle Cut
Down for Right Steering Trim
Up for Left Steering Trim
Up (0) is High
Down/Away (0) is High
Down (0) Smoke off
Up (1) Smoke on
Up/Away – Brakes off
Down/Pulled – Brakes on
48
Gear Aux1
Gear Left Ail
Seq.
Aux6 Aux7
Lights Open
10/8/2021