Selecting The Test Protocol; Starting A Test - Interacoustics OtoRead Instructions For Use Manual

3.12 Performing a test
3.12.1

Selecting the Test Protocol

3.12.2

Starting a test

D-0116684-B – 2020/03
OtoRead™ - Instructions for Use - US
The currently selected protocol is shown on the Main Menu.
To change the selected protocol press the
Main Menu. The Change Protocol menu will appear.
Use the CHANGE arrow buttons to change the selected protocol.
Press the UP key to return to the Main Menu to begin testing.
SETUP key to enter the setup menus.
Press the
For either DPOAE or TEOAE screener devices, there are two default
test protocols that vary based on averaging time (test time). Screener
default protocols cannot be customized. For diagnostic devices, there
is one default test protocol and a number of customizable protocols.
See Appendix C for an overview of the available protocls.
To begin a test, insert the probe into the ear and select either the
or RIGHT key depending on the ear to be tested.
NOTE: To measure emissions, gently insert the ear tip into the patient's
ear canal. It should fit snugly and comfortably. The best test results are
obtained when an ear tip is inserted deeply into the ear canal instead of
flush with the ear canal.
DOWN arrow at the
LEFT
Page 30