Surface Vertical Rod Installation Instructions - Assa Abloy Corbin Russwin ED5200N Series Installation Instructions Manual

ED5200N Series Exit Devices
If this is a Surface Vertical Rod installation, follow the installation instructions on pages 6 - 10 before continuing:
1. Install Inside Mounting Bracket with Outside Escutcheon:
a. Position outside escutcheon against door (Fig. 1-a). Insert gasket, if necessary.
b. Route antenna cable through door.
c. Route wires along the outside (not through) the mounting bracket (Fig. 1-b).
d. Secure with mounting bracket screws. Be careful not to damage wires.
CAUTION:
When attaching the mounting plate (and controller) to the mounting
bracket, keep in mind the following to prevent damage caused by
pinching wires:
• Make sure ElectroLynx connectors plug together between the
mounting plate and the side of the mounting bracket.
• Test proper functioning of unit before securing the mounting plate
and installing the escutcheon.
• The wires run THROUGH the hole in the mouting plate and out
through the gap in the side (Fig. 2).
• The wires run ALONG SIDE the mounting bracket and into the door.
Copyright © 2018 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the
express written permission of Corbin Russwin, Inc. is prohibited.

8) Surface Vertical Rod Installation Instructions

Ouside Escutcheon
Gasket
a
Mounting Bracket
b
Fig. 1
Fig. 2
14
d