Transport By Crane - ABB MNS-Up Service Manual

32 M N S - U P S E R V I C E M A N U A L
!
Sections may easily tip over when transported with a hand-pulled truck. Therefore the distance between the
wooden cross beam or the pallet and the ground should not be more than 3 mm (see Figure 3-15).
Figure 5-14 Transport with a hand-pulled truck
When using motor operated lifting truck or hand-pulled truck always check the position of gravity center mark.
!
Note, marking of transport section with gravity center is always requried for seaworthy transport, otherwise
the marking is optional.
5.4.2

Transport by crane

• For the transport by crane the shipping units are equipped with lifting angles (see Figure 3-15).
• Fastening of any Iifting device directly to the frame sections is not permitted.
• The lifting rope angle at the crane hook must not be larger than 120° (see Figure 3-16).
• The lifting angles may be removed after the switchgear has been erected.
• The fastening holes for the lifting angles are to be plugged with plugs if removing the lifting angles.
(see "4.13 Fastening of shipping sections")
Rope diameter [mm] Permissible load for a four-rope arrangement, rope angle at crane hook 120
Hamp rope acc. DIN 83325
[kg]
8 –
10 180
12 280
14 350
16 470
18 580
20 720
24 1000
30 1600
36 2400
Table 5-06: Guide values for permissible rope loading
max. 3 mm
Perlon ropes acc. DIN 83330
[kg]
×
400
600
820
1060
1340
1660
2400
–
–
Steel ropes acc. DIN 15060
(160 kg / mm )
2
[kg]
890
1440
2100
2900
–
–
–
–
–
–