T R A N S P O R T
—
Transport
6.1
MNS-Up section
• The MNS-Up sections must be shipped as individual sections, due to their dimensions and weight.
• ACB sections and MNS 3.0 sections may be shipped in sections of max 3 m in length or 3 sections. Shipping sections shall
only be transported in upright position
• For single empty sections, it is possible the to tilt the section carefully to side for transport, if the door height on site does
not allow upright transport
6.1.1
Rolling transport
Rolling transport of shipping sections up to 1200kg in weight with min. 3 rollers is possible. In case of higher weight, the
transport must be done with a forklift.
Figure 6-01
Rolling transport
6.1.2
Forklift transport
The transport pallets are supported with cross beams to allow the transport with a forklift or hand-lift truck
!
Sections may easily tip over when transported with a hand-lift truck. Therefore the distance
between the wooden cross beam or the pallet and the ground should not be more than 3 mm (see fig. 24).
Transport frame
(wooden beam
10 x 12 cm)
37