ABB MNS-Up Service Manual page 28

28 M N S - U P S E R V I C E M A N U A L
9. Location of crash and turnover protection (shockwatch label and tilt watch)
10. PE foil UV resistant shall be utilised on the top of the packing
Figure 5-09 Seaworthy packing procedure, steps 9 & 10
The switchgear shall be wrapped with foil after upholstering sharp edges and corners. The joints of the foil shall be sealed.
A protective drying agent according DIN 55474 shall be utilised between the foil and the switchgear. No direct contact of this
protective drying agent with the switchgear is allowed.
!
Only remove the packaging after delivery of the switchgear to site.
Only remove the transport frames from the section bases at the place of erection.