Return To Automatic Mode, Operating By Hmi - ABB Zenith ZTX Series Operation, Maintenance, And Installation Manual

30
Z e n i t h Z T X S e r i e s AT S , O P E R AT I O N , M A I N T E N A N C E , A N D I N S TA L L AT I O N G U I D E
ZTX : I - II
—
Fig. 3.4 Manual mode, operating by handle, open transition I - II
—
3.4 Return to Automatic
mode, operating by HMI
When operating the automatic transfer
switch by HMI, turn the slide switch to
Automatic mode (AUTO).
Notice
The handle has to be standby slot (not in use)
before turning to automatic mode.
When the slide switch is moved to the AUTO
position, the ATS will enter auto mode after
a 3 second delay.
I-position
1
—
Fig. 3.5 The operating handle must set back to
standby slot before moving to the automatic mode
II-position
2
3
Automatic
mode