Removing And Replacing The Cover And Front Bezel - HP Kayak XM600 User Manual

Removing the
Cover
Removing the
Front Bezel

Removing and Replacing the Cover and Front Bezel

For your own safety, it is recommended that you first read the warning
notices on pages 6 and 7.
1 Switch off the display and computer. Disconnect all power cables and
any LAN or telecommunications cables.
2 Unscrew the two thumb screws located at the back of the PC
Workstation.
3 Standing at the back of the PC Workstation, slide the cover towards you
until it clicks into place.
4 Tilt the cover sidewards, then lift off the PC Workstation chassis.

5 If required, remove the front bezel which is divided into two sections:
• The upper bezel (blue) gives access to three 5.25-inch shelves and two
3.5-inch shelves.
• The lower bezel (grey) gives access to the control panel. To access the
lower bezel, you must first remove the upper bezel.
2 Installing and Replacing Hardware Parts in Your PC Workstation
Removing and Replacing the Cover and Front Bezel
23