Sony STR-DN1010 Service Manual page 72

STR-DN1010
DSP BOARD IC5001 D788E002BRFP266 (DSP)
Pin No. Pin Name
1 Vss
2 AHCLIO0/AHCLKX2
3 AMUTE0
4 AMUTE1
5 AHCLKX1
6 Vss
7 ACLKX1
8 CVdd
9 ACLKR1
10 DVdd
11 AFSX1
12 AFSR1
13 Vss
14 RESET#
15 Vss
16 CVdd
17 CLKIN
18 Vss
19 TMS
20 CVdd
21 TRST#
22 OSCVss
23 OSCIN
24 OSCOUT
25 OSCVss
26 Vss
27 PLLHV
28 TDI
29 TDO
30 Vss
31 DVdd
32 EMU[0]#
33 CVdd
34 EMU[1]#
35 TCK
36 Vss
37 EM_CAS#
38 EM_WE#
39 EM_WE_DQM[0]
40 Vss
41 EM_D[7]
42 DVdd
43 EM_D[6]
44 CVdd
45, 46 EM_D[5], EM_D[4]
47 Vss
48, 49 EM_D[3], EM_D[2]
50 DVdd
51, 52 EM_D[1], EM_D[0]
53 CVdd
54 Vss
55, 56 EM_D[15], EM_D[14]
57 CVdd
58, 59 EM_D[13], EM_D[12]
60 DVdd
72
I/O
- Ground terminal
I Master clock signal input from the digital audio interface receiver and BD decoder
- Not used
- Not used
- Not used
- Ground terminal
O Bit clock signal output to the wireless transceiver and stream processor
- Power supply terminal (+1.2V)
I Bit clock signal input from the digital audio interface receiver and BD decoder
- Power supply terminal (+3.3V)
O L/R sampling clock signal output to the wireless transceiver and stream processor
I L/R sampling clock signal input from the digital audio interface receiver and BD decoder
- Ground terminal
I Reset signal input from the system controller "L": reset
- Ground terminal
- Power supply terminal (+1.2V)
- Not used
- Ground terminal
- Not used
- Power supply terminal (+1.2V)
- Not used
- Not used
I System clock input terminal (25 MHz)
O System clock output terminal (25 MHz)
- Not used
- Ground terminal
- Power supply terminal (+3.3V)
- Not used
- Not used
- Ground terminal
- Power supply terminal (+3.3V)
- Not used
- Power supply terminal (+1.2V)
- Not used
- Not used
- Ground terminal
O Column address strobe signal output to the SD-RAM
O Write enable signal output to the SD-RAM
O Byte enable signal output to the SD-RAM
- Ground terminal
I/O Two-way data bus with the SD-RAM
- Power supply terminal (+3.3V)
I/O Two-way data bus with the SD-RAM
- Power supply terminal (+1.2V)
I/O Two-way data bus with the SD-RAM
- Ground terminal
I/O Two-way data bus with the SD-RAM
- Power supply terminal (+3.3V)
I/O Two-way data bus with the SD-RAM
- Power supply terminal (+1.2V)
- Ground terminal
I/O Two-way data bus with the SD-RAM
- Power supply terminal (+1.2V)
I/O Two-way data bus with the SD-RAM
- Power supply terminal (+3.3V)
Description