Xtralis VESDA LCD Programmer Module Product Manual page 44

Xtralis VESDA LCD Programmer Product Guide
Scrn
Description
No.
122. Miscellaneous -
• Isolate remind - Provides an option to enable or disable the Beeper reminder for
Isolate function
• Latch Alarms - This provides a YES/NO option to latch/unlatch all Alarms
• Latch Faults - This provides a YES/NO option to latch/unlatch all Faults
123. LCD Programmer - Select the LCD Programmer and press
124. Status - Displays the current status for:
• Current User Level
• Current Access Level
• Faults
• Software Version Installed
• Configuration Code
125. Address (Zone) Number - If the LCD Programmer has been allocated a Address
(Zone) Number, it is displayed in this screen. This is only for VLS.
126. Location - Allocate a VESDA Zone name and location and assign these to the
LCD Programmer.
127. Power Supply Number - Input the number of the power supply that is assigned to
the detector. If the VESDA Intelligent power supply is not being used enter "0".
128. Address Control Lockout - This screen allows you to lock or unlock the button
functions on any Display in the VESDA Zone. This stops someone logging on at an
OPERATOR level from using the zone control or system control function. The
buttons controlled are:
• Mode/Test
• Silence/Scan
• Reset
• Isolate
129. Factory Defaults -
• Factory Defaults - To restore factory defaults, highlight Restore and press
• Defaults OK - Highlighting Start and pressing
Default settings and clear faults 12, 30, 31, 33, 34, 35, 38, 57, 68 and 72.
38
Parameter
Isolate Remind
Latch Alarm
Latch Fault
Default
Enabled
Enabled
Enabled
↵
.
↵
will acknowledge Factory
Xtralis VESDA
®
Min.
Access
Level
ADM
USR
USR
ADM
ADM
ADM
ADM
↵
. DST
ADM
www.xtralis.com