Xtralis VESDA LCD Programmer Module Product Manual page 34

Xtralis VESDA LCD Programmer Product Guide
Scrn
Description
No.
74. Relay Assignments - Each relay is allocated a screen. In their respective screens
assign the relevant alarm, fault, scanning or isolate function. Multiple functions can
be assigned to each relay. Relay 3 and relay 6 are permanently assigned to Urgent
Fault and Fire 1 functions respectively. Additional functions may be assigned to
Relays 3 and 6. Use the
75. Diagnostics - It is possible to conduct alarm and fault tests through sub-menus of
this screen.
• Alarm Test - This causes the detector to generate a Fire 2 condition
• Fault Test - This causes a system fault for 30 seconds
• Flow Fault - This causes a 30 second Air Flow fault
• Sector Test - This allows all valves to be forced closed and open
• Scan Test - This will perform a scan test
• Relay Test - (Refer to Screen 76).
76. Relay Test - This allows testing each relay by turning it ON and OFF.
77. Factory Defaults -
• Factory Defaults - To restore factory defaults, highlight Restore and press
• Defaults OK - Highlighting Start and pressing
Default settings and clear faults 12, 30, 31, 33, 34, 35, 38, 57, 68 and 72.
28
↵
key to assign or de-assign functions.
Parameter
Scanning
Sector 4
Sector 3
Sector 2
Sector 1
Fire 2
Fire 1
Action
Alert
Urgent Fault
Minor Fault
Isolate
Default
Relay 12
Relay 11
Relay 10
Relay 9
Relay 8
Relay 7
Relay 6
Relay 5
Relay 4
Relay 3
Relay 2
Relay 1
↵
will acknowledge Factory
Xtralis VESDA
®
Min.
Access
Level
ADM
ADM
ADM
DST
↵
.
ADM
www.xtralis.com