Navigating The Lcd Programmer; Logging On/Off The System; Automatic Log Off - Xtralis VESDA LCD Programmer Module Product Manual

Xtralis VESDA LCD Programmer Product Guide

Navigating the LCD Programmer

To navigate the menu tree of the LCD Programmer, to change or view parameters, and to
execute system functions, use the eight keys described in the table below.
Key Key Type
Soft
Soft
Hard
+
Hard
-
Hard
ESC
Hard
↵
Table 3 - Description of LCD Programmer keys and functions

Logging On/Off the System

It is not necessary to logon to view the data.
When the LCD Programmer is in a standby mode, pressing any key will display the logon screen.
To logon:
1. Against User enter the appropriate USER ID using the +/- keys to enter the letters
2. Press the
3. Enter PIN using the +/- keys
4. Use the and
↵
5. Press key after entering the PIN

Automatic Log Off

For security reasons, if you do not use the LCD Programmer for ten minutes it will automatically
log you off. Sixty and fifteen seconds before the programmer automatically logs you off it will
display a warning message and beep. Press any key on the programmer to stop the detector
from automatically logging you off.
8
Description
Directional Key/ Soft
Key Function
Directional Key/ Soft
Key Functions
Value Increasing
Action Key/Page Up
Value Decreasing
Action Key/Page Down
Backward Action Key
Forward Action Key
key to move cursor to the PIN field
keys to move from one field to the next (letter or digit)
Used For
• Moves Cursor to the left or right of the screen
• Scrolls highlighted item left/right
• Actions a soft key question
• Moves the cursor up or down on the screen
• Scrolls the Menu up or down
• Actions a soft key question
• Increases the value of the displayed number
• Adds a selected letter from the displayed
alphabet list.
• Page up on some screens
• Decreases the value of the displayed number
• Deletes a selected letter
• Page down on some screens
• Moves back up the Menu tree
• Any changes to parameters are actioned after
acknowledging the check message "Do you
want to save the changes?"
• Moves down the Menu tree by selecting the
highlighted option
• Adds selected letter
• Toggles between values
• Can be used to run Normalize, Autolearn, and
System/Address control commands
Xtralis VESDA
®
www.xtralis.com