Personal Identification Number (Pin); Hour Glass Symbol; Installing And Connecting The Lcd Programmer; Installing An Lcd Programmer In A Detector - Xtralis VESDA LCD Programmer Module Product Manual

Xtralis VESDA
®

Personal Identification Number (PIN)

The default PIN for each level of user is set at the factory. The distributor has access to the PINs
for each level. PIN numbers are disclosed to authorized personnel attending accredited Xtralis
VESDA training courses.
After logging in the user has the option to change the default PIN. To guard against unauthorized
access, if someone enters an incorrect PIN number three times they will not be allowed another
attempt for ten minutes.
A four digit number and an Xtralis VESDA contact phone number will be displayed on the screen.
No further entries can be made until instructions are received from Xtralis.

Hour Glass Symbol

After executing a command the hour glass symbol is displayed while the LCD Programmer is
waiting for updated data to be loaded from the system. To carry on working while the hour glass
symbol is displayed, press the Soft Key located below the CONT option displayed on the screen.
The hour glass symbol will automatically disappear once the data is received by the LCD
Programmer, if there is a large amount of information transferred to the LCD programmer this
may take several minutes.

5 Installing and Connecting the LCD Programmer

Installing an LCD Programmer in a Detector

The LCD Programmer module is snapped into the front cover of the Detector. For wiring details
please refer to the product guide for that detector.

Installing an LCD Programmer in a Remote Unit

Please refer to the Xtralis VESDA Remote Systems Product Guide for information on how to
install and connect an LCD Programmer to a remote unit or to the 19" sub rack.

Connecting the Hand Held LCD Programmer

The hand held LCD programmer is connected to a VESDAnet socket using a 15 pin D-type
connector. A VESDAnet socket is located on the head termination card in each detector. A
VESDAnet socket module can be mounted in the front cover of a remote unit or a 19" sub rack.
Connecting an LCD Programmer to VESDAnet will generate a network fault. To clear the fault,
select
SYSTEM ALL DEVICES

6 Operating the LCD Programmer

Standby Mode

The LCD Programmer is powered through VESDAnet. Once the LCD Programmer is powered up
the VESDA logo is displayed. This screen is also displayed when the LCD Programmer is in
standby mode.
www.xtralis.com
Xtralis VESDA LCD Programmer Product Guide
↵ ↵
S C
YSTEMS ONTROL
and R
ESET
7