Xtralis VESDA LCD Programmer Module Product Manual page 43

Xtralis VESDA
®
Scrn
Description
No.
119. Relay Assignments - Each relay is allocated a screen. In their respective screens
assign the relevant alarm, fault, scanning or isolate function. Multiple functions can
be assigned to each relay. Relay 3 and relay 6 are permanently assigned to Urgent
Fault and Fire 1 functions respectively. Additional functions may be assigned to
Relays 3 and 6. Use the
120. Factory Defaults -
• Factory Defaults - To restore factory defaults, highlight Restore and press
• Defaults OK - Highlighting Start and pressing
Default settings and clear faults 12, 30, 31, 33, 34, 35, 38, 57, 68 and 72.
121. Communications - The Communications screen allows settings for:
• Net Delay - This function sets the maximum time for a message to travel around
the network and return to the originating device. If the message does not return
within the prescribed time, it is presumed lost and will be resent
• Pref. Port - This allows you to assign a preferred port for communication
• Health Check - This function sets the frequency of health-check messages sent
around the system
• Open-ended - In an open ended VESDAnet loop select the port that is not
connected to the VESDAnet loop.
Parameter
Network delay
Preferred port
Health check
Open - ended
www.xtralis.com
Xtralis VESDA LCD Programmer Product Guide
↵
key to assign or de-assign functions.
Parameter
Scanning
Sector 4
Sector 3
Sector 2
Sector 1
Fire 2
Fire 1
Action
Alert
Urgent Fault
Minor Fault
Isolate
Default Minimum
15 seconds 10 seconds
A N/A
45 seconds 40 seconds
none N/A
Default
Relay 12
Relay 11
Relay 10
Relay 9
Relay 8
Relay 7
Relay 6
Relay 5
Relay 4
Relay 3
Relay 2
Relay 1
↵
will acknowledge Factory
Maximum
45 seconds
N/A
60 seconds
N/A
Min.
Access
Level
ADM
DST
↵
.
ADM
DST
37