Initial Programming With One Entry Panel - CAME BPT THANGRAM Programming Manual

Initial programming with ONE entry panel

>3''
1
Programming key type and address. Press the first key on the entry terminal C/CA/CB until the LED
the backlighting LEDs 4.
B
M2
CB
D
E
beep
6
0
100 °
82 °
1÷9
72 °
54 °
9
Accessing programming. Press the PROG key on the power supplier 1 until the
PROG
PROG LED turns on. If the PROG LED turns off suddenly, this indicates a malfunction in
the connection between the power supplier and the entry panel. Check the connections
and return to programming.
The entry panel LEDs turn on as shown in the figure 2.Wait 5 seconds for the self-test
to be completed and then continue as described below.
C
M3
BUTTON PANELS, the operation illustrated in figure C must be carried out as
illustrated in figure CC.
Programming the call keys. Lift the receiver (if present) of the extension that you want
to programme then press the door lock release
entry panel, press the call key to associate with the internal extension F: an acoustic
signal will confirm that the setting was stored. Hang up the receiver again, if necessary
and continue, repeating the same operations for the other extensions.
Exiting programming. Briefly press the PROG key on the power supplier G: the PROG
LED and entry panel LEDs will turn off. NOTE. If no action is performed, the procedure
will automatically end after 30 minutes.
7
2
6
7
4 1 5
9
8 3
J
M2
In the case that the call buttons are ONLY located on the ADDITIONAL PUSH
1
2
3
4
5
6
7
8
9
10
CC
<1''
PROG
Programming the entry panel surveillance camera. When
programming the call buttons, with switched off monitor, the
camera's "visual field" can be adjusted from any extension,
pressing the "self-connection
configuration, it is possible to scroll the next ones 9 pressing
the AUX1 key or return to the previous ones with the AUX2 key
J: the setting will be automatically saved.
M3
stops flashing as does
CA
and AUX2 E buttons. On the
8
" 8. Starting from the default