Advertisement
Connection example K
K
001DC002AC
001DC002AC
Programming
The kit is pre-configured to manage a single call originating from a single entry panel. One or more receivers answering the same call can be
added, by following the below "Call button programming" procedure.
Initial programming
PROG
a
SW3
e
M1
M2
– +
NO
C
B
B
–
VLS/300
001DC005AC
001DC005AC
Entering Programming Mode. Press the PROG a key for at least 3 seconds and then release it
>3''
(within 6 seconds), as soon as the LED PROG lights up and the key back lighting flashes as illustrated
<6''
in figure . Failure of the PROG LED to light up, indicates a malfunction. Check the connections and
re-access the programming mode.
Programming of the Key Type. Press the first key of the entry panel in the position indicated c/
cA until the backlighting LED stops flashing and remains lit.
PROG
c
SW3
M1
Programming the call keys. Lift the receiver (if present) of the extension that you want to programme
BOUT
e then press the door lock release
key to associate with the internal extension g: an acoustic signal will confirm that the setting was
PROG
stored. Hang up the receiver again, if necessary h and continue, repeating the same operations for
the other extensions.
SW3
f
–
+
BOUT
and AUX2 f buttons. On the entry panel, press the call
M2
M1
c A
M1
BOUT
beep
g
PROG
M2
SW3
M2
Advertisement
