Page 1
Audio and video FB00865-EN entry panel DVC/01-DVC/01ME DC/01-DC/01ME EN English PROGRAMMING MANUAL...
Page 2
General precautions Read the instructions carefully before beginning the installation and carry out the actions as specifi ed by the manufacturer. • The installation, programming, commissioning and maintenance of the product must only be carried out by qualifi ed technicians, •...
Manual programming of entry panels It is possible to programme only one or several audio/video entry panels that have the same calls (unless "blind units" are used that disable one or more of them). It is possible to programme entry panels (connected to the same power supply) with diff erent types of keys, still respecting the se- quence shown on the left.
Page 6
PROGRAMMING ENTRY PANELS WITH VA/01 First Programming with ONE entry panel Entering Programming Mode. Press the PROG key on the power supply 1 until the PROG LED lights up. If the PROG LED immediately goes out, this indicates a malfunction PROG PROG in the connections between the power supply and the entry panel.
Page 7
Entry panel brightness level adjustment. While programming the call keys the entry panel brightness level can be adjusted from any receiver. Pressing the "Self-connec- tion" key on the receiver causes the video camera of the entry panel for which the brightness level is to be adjusted to be activated.
Exiting Programming. Briefl y press the PROG key on the power supply: the PROG LEDs and the LEDs on the entry panels will go out. NOTE. If no action is performed, the procedure will end automatically after 30 minutes. Programming entry panel video cameras. While programming the call keys the "visual range" of the video camera can be adjusted in the way already described.
If all the entry panels are reprogrammed, the confi guration will be as shown in fi gure J. To exit reprogramming, briefl y press the PROG key on the power supply K: the PROG PROG >3’’ >3’’ PROG LEDs and the LEDs on the entry panels will go out. If no action is performed, the procedure will end automatically after 30 minutes.
Page 10
Programming the door release code and relay with DNA. Press and key in the 1-2-3 1-2-3 relay code you wish to programme (press key 1 to activate the door opening control in the entry panel; press key 2 to activate relay 1 on the VLS/2 relay module; press key 3 to activate relay 2 on the VLS/2 relay module) 7.
Page 11
Deleting Codes and Tags Position the power supply's PROG RFID jumper at “–” 1: the power supply's PROG LED will fl ash slowly, along with the message LEDs with the confi guration in fi g. 2. If the LEDs immediately go out it means there is a malfunction in the connections between the power supply and the entry panel.
Page 12
PROGRAMMING ENTRY PANELS WITH VAS/100.30 or VAS/101 First Programming Entering Programming Mode. Press the PROG key 1 for at least 3 seconds and release within 6 seconds. If the PROG LED immediately goes out it means there is a >3’’ >3’’...
Page 13
Programming entry panel video cameras. While programming the call keys the “visual range” of the video camera can be adjusted from any receiver (with handset PROG key 8. From the default raised, it there is one), by pressing the “Self-connection” <1’’...
Page 14
Exiting Programming. Briefl y press the PROG key 7: the PROG LEDs and entry panel LEDs will go out. If no action is performed, the procedure will end automatically after <1’’ <1’’ PROG 30 minutes. Programming Type of Keys. In “Programming Call Keys” 2 press the PROG key 8 and release it within 6 seconds to go into the “Programming Type of Keys”...
Page 16
CAME S.p.A. Via Martiri Della Libertà, 15 31030 Dosson di Casier - Treviso - Italy tel. (+39) 0422 4940 - fax. (+39) 0422 4941...