Programming With Dna - CAME BPT THANGRAM Programming Manual

K
When adding, replacing or removing an entry panel, the acquisition of the modifications is done during the phase "Pro-
gramming key type" (figure F-K).

Programming with DNA

1
2
3
4
5
6
7
8
9
M2
10
Accessing programming. Press the PROG key on the power supplier for more than 3 seconds 1. The entry panel LEDs turn on
as shown in the figure 2. If the PROG LED turns off suddenly, this indicates a malfunction in the connection between the power
supplier and the entry panel. Check the connections and return to programming. Repeat the operation 3 a second time. Check that
A
B
M2
3
E
M2
G
External entry panel illumination level adjustment. During call button programming
PROG
the external entry panel illumination level can be adjusted up or down as previously
described.
In the case that the call buttons are ONLY located on the ADDITIONAL PUSH
BUTTON PANELS, proceed as indicated in NOTE on page 7.
For this type of entry panel configuration,
refer to the previously described proce-
dures.
M3
the entry panel configuration is as illustrated in figure D. Wait 5 seconds for the self-test
PROG
to be completed and then continue as described below.
Programming the call codes. Lift the receiver (if present) of the extension that you want
to programme then press the door lock release
call code for the group (1 to 99) and then press
internal extension. Hang up the receiver again, if necessary and continue, repeating the
PROG
M3
4
XX
F
Exiting programming. Briefly press the PROG key on the power supplier G: the PROG
PROG
LED and entry panel LEDs will turn off. NOTE. If no action is performed, the procedure
M3
will automatically end after 30 minutes.
For this type of entry panel configuration, refer to the
procedures described below.
same operations for the other extensions. The operation may only
be performed from the entry panel with the LED
to change the entry panel from which call programming press key
1 followed by key .
beep
+
and AUX2 E buttons. Enter the
F to associate the code key with the
off (PE1 in D):