Connection example M
M
VAS101
Programming
The kit is pre-configured to manage a single call originating from a single entry panel. One or more receivers answering the same call
can be added, by following the below "Call button programming" procedure.
Initial programming
PROG
a
SW3
M1
M2
– +
NO
C
B
B
–
VLS/300
VLS/300
Accessing programming. Press the PROG button a for at least 3 seconds and re-
>3''
lease it (within 6 seconds) as soon as the PROG LED comes on and the backlighting
<6''
on the buttons flashes as shown in figure . If the PROG LED does not come on, this
shows a fault. Check the connections and go back to programming.
Programming button type. Press the first button on the entry panel in the position
marked /A until the backlit LEDS stop flashing and remain lit.
PROG
SW3
M1
BOUT
Programming the call keys. Press the door lock release
On the entry panel, press the call key to associate with the internal extension : an
acoustic signal will confirm that the setting was stored. Hang up the receiver again.
PROG
Repeat the same operations for the other extensions.
SW3
–
+
BOUT
M2
beep
M1
A
M1
BOUT
and AUX2 buttons.
PROG
M2
SW3
M2