Viewing Device Status; Upgrading The Device - Larson Electronics EXPCMR-CER-IP-POE-4MP-IR-V3 User Manual

Setting the DST
1. Click Setup > Common > Time, and then click the DST tab.
2. Select On for DST, set the start time, end time, and DST bias.
3. Click Save.

Viewing Device Status

1. You can view the current status of your camera.
2. Click Setup > Common > Basic Info.
3. Click Refresh for the latest status information.
4. View the device information.

Upgrading the Device

If the device is managed by the central management server and you want to upgrade the devices in
batch mode, it is recommended to perform the upgrade operation on the central server. For detailed
steps, see the user manual for the central management server.
1. Click Setup > System > Maintenance.
2. Under Firmware Upgrade, click Browse and select the correct upgrade file.
3. (Optional) Select the check box to enable Upgrade Boot Program.
4. Click Upgrade and then confirm to start. The camera will restart automatically after the upgrade
is completed.
NOTE:

You must use the correct upgrade file for you camera. Otherwise, unexpected results may
occur.

The upgrade file is a ZIP file and must include all the necessary files.

The boot program loads the operating system and then the system starts running. The
upgrade boot program function is disabled by default, and only the camera will be upgraded
46