Larson Electronics EXPCMR-CER-IP-POE-4MP-IR-V3 User Manual page 51

2. Select On to enable IP address filtering.
3. Select the filtering mode and then enter the desired IP address(es).
4. Click Save.
NOTE:

If the filtering mode is set to Whitelist, only the specified IP addresses are allowed to
access the camera. If the filtering mode is set to Deny Access, the specified IP addresses
are denied for the access.

Up to 32 IP addresses are allowed. And the added IP addresses cannot duplicate.

The first byte of the IP address can only be a number ranging from 1 to 223 and the fourth
byte cannot be 0. For example, 0.0.0.0, 127.0.0.1, 255.255.255.255 and 224.0.0.1 all are
invalid IP addresses.
Access Policy
Enabling friendly password does not affect use. If you turn it off and log in with a weak
NOTE:
password, a page will pop up, prompting you to change the password. There is no Cancel or Close
button on this page. The default password is treated as weak.
1. Click Setup > Security > Network Security > Access Policy.
2. Select On to enable friendly password and MAC Authentication.
3. Click Save.
Hide Vendor Information
You can set to hide the vendor information of the network camera on the Web interface.
1. Click Setup > Security > Registration Info.
2. Select On.
3. Click Save.
44