Logging In To The Web Interface - Larson Electronics EXPCMR-CER-IP-POE-4MP-IR-V3 User Manual

Logging In to the Web Interface

The default static IP address of the camera is 192.168.0.100, and the default subnet mask is
255.255.255.0.
DHCP is turned on by default. If a DHCP server is used in the network, the IP address of your camera
may be assigned dynamically, and you need to use the correct IP address to log in. Use the video
management software to view the dynamic IP address of your camera.
The following takes IE as an example to describe the login procedure.
1. Browse to the login page by entering the correct IP address of your camera in the address bar.
2. If you log in for the first time, follow system prompts and install the ActiveX. You need to close
your browser to complete the installation.
NOTE:

To manually load the ActiveX, type http://IP address/ActiveX/Setup.exe in the address bar
and press Enter.

The default password is used for your first login. To ensure account security, please change
the password after your first login. You are recommended to set a strong password (no less
than eight characters).

The camera protects itself from illegal access by limiting the number of failed login attempts.
If login fails six times consecutively, the camera locks automatically for ten minutes.
3. Enter the username and password, and then click Login. For the first login, use the default
username admin and password 123456.
If you log in with Live View selected, live video will be displayed when you are logged in.
Otherwise, you need to start live video manually in the live view window.
If you log in with Save Password selected, you do not need to enter the password each time
when you log in. To ensure security, you are not advised to select Save Password.
To clear the Username and Password text boxes and the Save Password check box, click
Reset.
4