Gv-Tower Vms System V2 (Rev. C) - GeoVision GV-Tower System V2 User Manual

3.8.2 GV-Tower VMS System V2 (Rev. C)

You can customize the display settings of GV-VMS. Click Home
select Configure , select System Configure, and click Set Position. This dialog box
appears. The right side of the dialog box is only available when multiple monitors are installed.
Select Monitor: If you have multiple monitors connected, select the monitor you want to

configure from the drop-down list.
Position: Offsets the position of the GV-VMS window relative to the upper-left corner of

the screen. The default position is 0, 0. A position of 100, 60 will place the GV-VMS
window 100 pixels to the right and 60 pixels below the upper-left corner. This function is
only supported when the GV-VMS window does not take up the entire screen.
Panel Resolution: Sets the Panel Resolution of GV-VMS.

26
Figure 3-28
Figure 3-29
, select Toolbar ,