Wiring A Power Connection; Audio/Video Port: Connections And Wiring - AMX Modero NXD-1200V Operation/Reference Manual

Installation Procedures: NXD-1200V Panels

Wiring a power connection

To use the 2-pin 3.5 mm mini-Phoenix connector with a 12 VDC-compliant power supply, the incoming
PWR and GND wires from the external source must be connected to their corresponding locations on the
connector (FIG. 43).
PWR +
GND -
To the Touch Panel
FIG. 43 NetLinx power connector wiring diagram
1. Insert the PWR and GND wires on the terminal end of the 2-pin 3.5 mm mini-Phoenix cable.
Match the wiring locations of the +/- on both the power supply and the terminal connector.
2. Tighten the clamp to secure the two wires. Do not tighten the screws excessively; doing so may strip
the threads and damage the connector.
3. Verify the connection of the 2-pin 3.5 mm mini-Phoenix to the power supply.

Audio/Video Port: Connections and Wiring

The following table shows the signal and pinout/pairing information used on the RJ-45 Audio and Video
connections.
Audio/Video RJ-45 Pinout Information
Pin
1
2
3
4
5
6
7
8
(female)
Refer to the Installing CAT5 Suppression Ferrites section on page 14 for detailed information on how to
install the necessary number of CAT5 Suppression Ferrites on the Black A/V RJ-45 cable connected to
the panel.
46
Wire Color Function
Orange/White Right Audio In
Orange Right Audio In
Green/White Video In
Blue Mic Out
White/Blue Mic Out
Green Video In
White/Brown Left Audio In
Brown Left Audio In
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
RJ-45 connector - pin configurations
Power Supply
Polarity
+
-
-
-
+
+
+
TIA 568B
-
(male)
1200V Modero Video Touch Panels