Wiring A Power Connection - AMX MXT-2000XL-PAN Operation/Reference Manual

Installation
Connecting power to the MXT-2000XL-PAN should be done using the included 2-pin
3.5mm captive wire connector included with the device. This connector is retained
within its port with locking screws instead of the pins on each side of standard captive
wire connectors, and using force to insert a standard captive wire connector may
damage the device.

Wiring a Power Connection

To use the 2-pin 3.5 mm captive wire connector with a 12 VDC-compliant power supply, the incoming PWR
and GND wires from the external source must be connected to their corresponding locations on the connector
(FIG. 11). The connector uses locking screws to insure a connection to the device, so make sure to insert and
tighten the screws before applying power.
PWR +
GND -
To the Touch Panel
FIG. 11 NetLinx power connector wiring diagram
1.
Insert the PWR and GND wires on the terminal end of the 2-pin 3.5 mm captive wire cable. Match the
wiring locations of the +/- on both the power supply and the terminal connector.
2.
Tighten the clamp to secure the two wires. Do not tighten the screws excessively; doing so may strip the
threads and damage the connector.
3.
Verify the connection of the 2-pin 3.5 mm captive wire to the external 12 VDC-compliant power supply
and apply power.
16 MXD/T-2000XL-PAN 20.3" Modero X Series® Panoramic Touch Panels
Power Supply