AMX Modero NXD-1200V Operation/Reference Manual page 49

Install the four #4-40
screws into the places
A - Faceplate
(bezel)
FIG. 37 Wall Mount panel installation configuration for pre-existing conduit/wallbox in a pre-wall construction
Don't disconnect the connectors from the touch panel. The unit must be installed with
the attached connectors before being inserted into the conduit box.
6. Carefully slide the main unit (B in FIG. 37) into the conduit box, so the Mounting Tabs lie flush
against the conduit box (C in FIG. 37).
7. Insert and secure the four securing #4-40 Mounting Screws into their corresponding holes located
along the sides of the NXD (FIG. 36 and FIG. 37).
8. Place the magnetic faceplate (A in FIG. 37) back onto the main NXD unit (B in FIG. 37).
Make sure to align the Microphone, Light, and PIR Motion sensor locations to their respective
openings on the front bezel/faceplate.
9. Reconnect the terminal RJ-45, Ethernet, USB, and any optional audio/video wiring to their
respective locations (outside the conduit box) on either the NXA-AVB/ETHERNET Breakout Box,
Ethernet port, or NetLinx Master.
10. Reconnect the terminal power connector on the 12 VDC-compliant power supply and apply power.
1200V Modero Video Touch Panels
Stud
Cable
knockouts
Mounting Tab
indicated
Installation Procedures: NXD-1200V Panels
SURFACE
Do not use these
tabs to mount
the conduit /wallbox
These are ONLY used to
secure the main unit to the CB
B - Main NXD unit consists of
the touch panel and backbox housing
C - Optional CB-TP
conduit/wallbox
Installed flush
against the
finished wall
surface
39