Step 3: Install The Compact Flash Memory Card Upgrade - AMX Modero NXD-1200V Operation/Reference Manual

Step 3: Install the Compact Flash Memory Card upgrade

1. Discharge any static electricity from your body by touching a grounded metal object and then locate
the existing Compact Flash card (factory-shipped with 128 MB) on the main board (FIG. 20 for
Table Top panels and FIG. 23 for Wall Mount panels).
NXA-PCI80211G
I/O connector
Eight Housing
Screws
FIG. 20 Location of the Compact Flash card and I/O plate on NXT
2. Insert the tip of a grounded flat-head screwdriver into one of the card removal grooves (located on
either side of the existing card), and gently pry the card out of the slot (FIG. 21). Repeat this process
on the opposite card removal groove. This alternating action causes the card to "wiggle" away from
the on-board connector pins.
Card removal
Insert with arrow
facing towards the pins
FIG. 21 Removing/installing a Compact Flash Memory card
3. Grip the old card by its sides and then carefully pull it out of the slot.
4. Remove the new CF memory card from it's anti-static bag.
1200V Modero Video Touch Panels
wireless card
plate
grooves
Touch Panel Accessories
Outer Housing
Compact Flash card
On-board Compact
Flash connector (with pins)
Connector opening
21