Wireless Settings Page - AMX Modero NXD-1200V Operation/Reference Manual

Firmware Pages and Descriptions

Wireless Settings Page

The Wireless Settings page (FIG. 100) sets the communication information for the installed wireless
interface card. This information includes its corresponding IP communication parameters, wireless
communication settings, and read the device number assigned to the Modero panel. These panels can use
the NXA-PCI80211G wireless card for wireless communication. This card also supports Wired
Encryption Protocol (WEP) encryption of 64-bit and 128-bit key lengths. Refer to both the Wireless
Settings Page - Wireless Access Overview section on page 59 and Configuring a Wireless
Connection section on page 60 for more detailed information of setting up the Modero panel for wireless
network access.
FIG. 100
Wireless Settings page (showing default values)
The elements of the Wireless Settings page are described in the table below:
Wireless Settings Page Elements
Back:
Connection Status icon:
IP Settings:
DHCP/STATIC
IP Address
Subnet Mask
114
Red
Blue
Grey
Saves the changes and returns you to the previously active touch panel page.
This visual display of the connection status allows the user to have a current
visual update of the panel's connection status regardless of what page is
currently active.
• A Lock only appears on the icon if the panel has established a connection
with a currently secured target Master (requiring a username and password).
Sets the IP communication values for the touch panel and contains:
Sets the panel to either DHCP or Static communication modes.
• DHCP (Dynamic Host Configuration Protocol) assigns IP Addresses to client
stations logging onto a TCP/IP network from a DHCP server.
• Static IP is a permanent IP Address that is assigned to a node in a TCP/IP
network.
Note: If DHCP is selected, the following fields become read-only: IP Address,
Subnet Mask, Gateway, Primary DNS, Secondary DNS, and Domain.
Sets the secondary IP Address assigned to the panel.
Sets a subnetwork address to the panel.
• Subnetwork mask is the technique used by the IP protocol to filter messages
into a particular network segment (subnet).
IP Settings section
Wireless Settings section
fields are user-editable
fields cycle through choices
fields are read-only
1200V Modero Video Touch Panels