Step 2: Install The Compact Flash Memory Card Upgrade - AMX Modero NXD-CV10 Operation/Reference Manual

CV10 Touch Panel Accessories
3. While holding the outer housing and base plate at an angle (to prevent it from sliding), use a
grounded Phillips-head screwdriver to remove the four Housing Screws.
Note the location of the four plastic adhesive "feet". Once the outer housing is placed
back onto the panel, these "feet" must be placed back onto their original locations so
they can fit into their provided openings on a Battery Base.
4. Rotate the panel back over (while gripping the entire unit and outer housing) and rest the base back
onto a flat surface.
5. Gently tilt the LCD panel backwards to expose the Tilt Bracket/Speaker assembly (FIG. 19).
Outer Housing
FIG. 19 Location of the Tilt Bracket screws
6. Locate the two screw holes at either sides of the front speaker grill and then use a grounded
Phillips-head screwdriver to remove the two Tilt Bracket Screws (FIG. 19). This procedure both
loosens the rear Tilt Bracket cover plate (with the AMX logo and Hinge brackets) and provides
greater flexibility for the removal of the outer housing. Without this step, the Hinge brackets
(FIG. 19) present an obstacle to the removal of the outer housing and restrict access to the circuit
board.
7. Tilt the LCD panel back up to gain better access to the Tilt Bracket cover plate.
8. In a single motion, carefully pull both the Tilt Bracket cover plate and outer housing up and then out
(away from the LCD panel) to expose the internal circuit board (FIG. 20).

Step 2: Install the Compact Flash Memory card upgrade

1. Discharge any static electricity from your body by touching a grounded metal object and then locate
the existing 64 MB Compact Flash card on the main board (FIG. 21).
2. Insert the tip of a grounded flat-head screwdriver into one of the card removal grooves (located on
either side of the existing card), and gently pry the card out of the slot (FIG. 22). Repeat this process
on the opposite card removal groove. This alternating action causes the card to "wiggle" away from
the on-board connector pins.
3. Grip the old card by its sides and then carefully pull it out of the slot.
22
Hinge Brackets (2)
Tilt Bracket/Speaker assembly
Tilt Bracket Screws (2)
These two screws must
first be removed before
being able to remove
the outer housing.
Base
10" Modero Widescreen Touch Panels