Step 2: Installing The Upgrade Compact Flash Card - AMX NXD-CA12 Operation/Reference Manual

Touch Panel Accessories
Outer Housing
FIG. 19 Location of the Compact Flash and memory modules on NXT panel main board

Step 2: Installing the Upgrade Compact Flash Card

1.
Discharge any static electricity from your body by touching a grounded metal object.
2.
Locate the 64 MB Compact Flash card (FIG. 20) on the main board.
3.
Insert a grounded flathead screwdriver into one of the card removal grooves (located on either side of the
card), and gently pry the card up and off the connector pins (FIG. 20). This alternating action causes the
card to "wiggle" away from the on-board connector pins.
Under-side indention
located below
Insert with arrow
facing towards the pins
FIG. 20 Removing the Compact Flash card
4.
Slip your finger into the opening between the connector pins and the card, and push the card out to
remove it.
5.
Remove the upgrade card from its' anti-static bag.
6.
Insert the upgrade card into the connector opening with the arrow facing towards the pins, then push it in
firmly until the contact pins are completely inside the Flash Card and securely attached to the connector.
22
Speaker grills
Base
Tilt bracket
On-board Compact
Flash connector
Memory Module
Compact Flash
12" and 15" Modero Touch Panels