1. Align the front HDD with the anchor point on the tray.
2. Assemble 2.5" SSD into the tray by three screws from the bottom as shown.
NOTE:
To ensure proper system airflow requirements, all front drive bays are suggested to populate with a 3.5" drive tray where
it is supposed to be installed with a 3.5" drive, a 2.5" drive with plastic dummy filler or only dummy fillers. In addition, in order
to support a 2.5" drive in a 3.5" tray, a screw-type tray is required.
NOTE: Dedicated screw type is required for 2.5" SSD Installation, Chenbro P/N: 384-14602-3143A0.
Figure 22 2.5" HDD installation (screw type)
System Components Installation and Removal
SR107 Plus Series
22
│