Figure 18 3.5" Hdd Installation - Chenbro RM245 Series User Manual

1. Engage two embossed pin into the side dimples on the HDD as shown
2. Carefully push down the other side of HDD until another two embossed pin and side dimples lock into place
NOTE:
Due to degraded performance and reliability concerns, the use of the 3.5" drive blank as a 2.5" device bracket is
intended to support SSD type storage devices only. Installing a 2.5" hard disk drive into the 3.5" drive blank cannot be
supported.

Figure 18 3.5" HDD Installation

RM245 Series
/ Installation 22
│