Table of Contents
Advertisement
1. Align front HDD with the anchor point on the tray.
2. Slide in HDD at an angle and push down carefully.
NOTE:
Due to degraded performance and reliability concerns, the use of the 3.5" drive blank as a 2.5" device bracket is
intended to support SSD type storage devices only. Installing a 2.5" hard disk drive into the 3.5" drive tray cannot be
supported.
1. Align front HDD with the anchor point on the tray.
2. Assemble 3.5" HDD with tray by 4 screws on the side of tray.
Figure 19 3.5" HDD Installation (Tool-less)
Figure 20 3.5" HDD Installation (Screw)
RM133 Series
/ Installation
22
│
Advertisement
Table of Contents
