Advertisement
Step-by-Step Build Guide (cont'd)
3D Printing Tips (cont'd)
Standard Materials Extrusion Multiplier (Flow):
You will need to experiment with extrusion multiplier for
your particular printer and material. You will likely land
somewhere between 0.95 and 1.05 extrusion multiplier.
Elephant's Foot:
Try to avoid the first few layers of each print from
squishing too far outside the designed wall dimensions,
also known as "elephant's foot". This can be caused by
your nozzle being too close to the print bed or first layer
width set too high in your slicer. A small amount of
elephant's foot is okay but too much will interfere with
the designed alignment aids.
3D
Aeroventures
Support Structures:
The "Fuse Tray 3" part of this aircraft requires
support structures and it's recommended to
use your slicer's auto-generated support
structures. The GCode and the Simplify3D
Factory Files already have the support structures
in place.
www.3daeroventures.com
w�w�3�A�r�v�n�u�e�.�o�
N�v�r S�o� E�p�o�i�g� N�v�r S�o� Q�e�t�o�i�g� N�v�r S�o� P�a�i�g
- 9 -
Advertisement
