Advertisement
Step-by-Step Build Guide (cont'd)
Step 2.5 Glue Fuselage and Fuse Tray Parts Together
ATTENTION: The fuselage is designed with separate Fuse Tray parts. This was done
in case you choose to print the Fuse parts in LW-PLA or LW-ASA. The Fuse Tray parts
should be printed in a more rigid plastic like standard PLA, ABS, PETG, or PC.
The Fuse parts must be assembled with the Fuse Tray parts in a certain order. You
will notice the Fuse Tray parts slide into rails located in the Fuse parts. The Trays
overlap the seams of the Fuse parts and make for a very strong, rigid fuselage.
DO NOT GLUE ALL OF THE FUSE PARTS TOGETHER
WITHOUT THE FUSE TRAY PARTS IN PLACE!
www.3daeroventures.com
w�w�3�A�r�v�n�u�e�.�o�
3D
- 1� -
Aeroventures
N�v�r S�o� E�p�o�i�g� N�v�r S�o� Q�e�t�o�i�g� N�v�r S�o� P�a�i�g
Advertisement
