Advertisement
Step-by-Step Build Guide (cont'd)
Step 2.1 Bend the Tailwheel Wire to Shape
ATTENTION: Do not glue Fuse 7 into place without the tailwheel wire set in place
between Fuse 6 and Fuse 7. Print out the drawing of the tailwheel wire on the
following page to aid in bending a 1.8mm - 2mm diameter steel wire to the proper
shape. Set aside for a later step.
3D
Aeroventures
w�w�3�A�r�v�n�u�e�.�o�
www.3daeroventures.com
N�v�r S�o� E�p�o�i�g� N�v�r S�o� Q�e�t�o�i�g� N�v�r S�o� P�a�i�g
- 1� -
Advertisement
