Advertisement
Step-by-Step Build Guide (cont'd)
2.5.4 Repeat Steps 2.5.2 and 2.5.3 for the remainder of the Fuse and Fuse Tray parts,
followng the order shown in the image below.
ATTENTION: Stop after gluing part Fuse 6 in place. Do not glue Fuse 7 into place
without the tailwheel wire set between Fuse 6 and Fuse 7. Print out the drawing
of the tailwheel wire on page 12 to aid in bending a 1.8mm - 2mm diameter steel
3D
Aeroventures
wire to the proper shape.
Fuse 3 (PLA)
www.3daeroventures.com
w�w�3�A�r�v�n�u�e�.�o�
N�v�r S�o� E�p�o�i�g� N�v�r S�o� Q�e�t�o�i�g� N�v�r S�o� P�a�i�g
Fuse 4
Fuse Tray 4 (PLA)
Fuse Tray 3 (PLA)
Fuse 6
Fuse 5
Fuse Tray 5 (PLA)
- 1� -
Advertisement
