Step-by-Step Build Guide (cont'd)
2.5.5 Rest the bent tailwheel wire in place in Fuse 7 and glue Fuse 7 to Fuse 6, taking
care not to get any adhesive on the tailwheel wire. Once assembled, the
90 degree bend that is at the top of the tailwheel wire should stick out the back
as shown in the figures below. This is the portion of the wire that will engage
with the rudder during final assembly.
3D
Aeroventures
www.3daeroventures.com
w�w�3�A�r�v�n�u�e�.�o�
N�v�r S�o� E�p�o�i�g� N�v�r S�o� Q�e�t�o�i�g� N�v�r S�o� P�a�i�g
- 1� -